I2C and SPI (4 wire) driver for the SSD1306 OLED display.
See the announcement blog post for more information.
Please consider becoming a sponsor so I may continue to maintain this crate in my spare time!
From examples/image_i2c.rs
:
```rust
use cortexmrt::{entry, exception, ExceptionFrame}; use embeddedgraphics::{ image::{Image, ImageRaw}, pixelcolor::BinaryColor, prelude::*, }; use panichalt as ; use ssd1306::{prelude::*, Builder, I2CDIBuilder}; use stm32f1xxhal::{ i2c::{BlockingI2c, DutyCycle, Mode}, prelude::*, stm32, };
fn main() -> ! { let dp = stm32::Peripherals::take().unwrap();
let mut flash = dp.FLASH.constrain();
let mut rcc = dp.RCC.constrain();
let clocks = rcc.cfgr.freeze(&mut flash.acr);
let mut afio = dp.AFIO.constrain(&mut rcc.apb2);
let mut gpiob = dp.GPIOB.split(&mut rcc.apb2);
let scl = gpiob.pb8.into_alternate_open_drain(&mut gpiob.crh);
let sda = gpiob.pb9.into_alternate_open_drain(&mut gpiob.crh);
let i2c = BlockingI2c::i2c1(
dp.I2C1,
(scl, sda),
&mut afio.mapr,
Mode::Fast {
frequency: 400_000.hz(),
duty_cycle: DutyCycle::Ratio2to1,
},
clocks,
&mut rcc.apb1,
1000,
10,
1000,
1000,
);
let interface = I2CDIBuilder::new().init(i2c);
let mut disp: GraphicsMode<_, _> = Builder::new().connect(interface).into();
disp.init().unwrap();
let raw: ImageRaw<BinaryColor> = ImageRaw::new(include_bytes!("./rust.raw"), 64, 64);
let im = Image::new(&raw, Point::new(32, 0));
im.draw(&mut disp).unwrap();
disp.flush().unwrap();
loop {}
}
fn HardFault(ef: &ExceptionFrame) -> ! { panic!("{:#?}", ef); }
```
Licensed under either of
at your option.
Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.