Note: Requires requires nightly 2018-08-27 or later. Install with
rustup override set nightly-2018-08-27
.
I2C and SPI (4 wire) driver for the SSD1306 OLED display for use with RTFM.
See the announcement blog post for more information.
From examples/image_i2c.rs
:
```rust
extern crate cortexm; extern crate embeddedgraphics; extern crate embeddedhal as hal; extern crate ssd1306; extern crate stm32f103xxhal as blue_pill;
use bluepill::i2c::{DutyCycle, I2c, Mode}; use bluepill::prelude::*; use embeddedgraphics::Drawing; use embeddedgraphics::image::{Image, Image1BPP}; use embedded_graphics::transform::Transform; use ssd1306::{Builder, mode::GraphicsMode};
fn main() { let dp = bluepill::stm32f103xx::Peripherals::take().unwrap(); let mut flash = dp.FLASH.constrain(); let mut rcc = dp.RCC.constrain(); let clocks = rcc.cfgr.freeze(&mut flash.acr); let mut afio = dp.AFIO.constrain(&mut rcc.apb2); let mut gpiob = dp.GPIOB.split(&mut rcc.apb2); let scl = gpiob.pb8.intoalternateopendrain(&mut gpiob.crh); let sda = gpiob.pb9.intoalternateopen_drain(&mut gpiob.crh);
let i2c = I2c::i2c1(
dp.I2C1,
(scl, sda),
&mut afio.mapr,
Mode::Fast {
frequency: 400_000,
duty_cycle: DutyCycle::Ratio1to1,
},
clocks,
&mut rcc.apb1,
);
let mut disp: GraphicsMode<_> = Builder::new().connect_i2c(i2c).into();
disp.init().unwrap();
disp.flush().unwrap();
let im = Image1BPP::new(include_bytes!("./rust.raw"), 64, 64).translate(Coord::new(32, 0));
disp.draw(im.into_iter());
disp.flush().unwrap();
} ```
Licensed under either of
at your option.
Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.