plotcap

Introduction

plotcap is a small command line utility for plotting the packet and data rates of the network traffic in a PCAP file.

It aggregates three measurements at regular intervals (default of 1s, but adjustable via the -i argument) seconds:

• Packet count
• Bytes on the wire
• Bytes captured (different from the wire size if snaplen is less than the packet size)

plotcap then writes an executable gnuplot script that embeds the data for the above measurements and plots them on two Y axis (left for packets per second, right for Bytes per second) with relative time on the X axis.

Because the output file can be relatively small, you can easily copy it off the system where plotcap is executed (a handy trick in constrained environments, especially with a statically linked binary - see the section below) and then execute the script on your laptop (or any GUI system with gnuplot installed) for visualisation.

Note that the output script runs gnuplot in persistent mode (-p) and uses pause mouse close to allow interaction with the plot. This is useful for zooming into areas (try right-click and drag).

Building

To install the latest version of plotcap, ensure you have a Rust toolchain installed, then run:

shell cargo install plotcap

Or, to build from source (binary in target/release/plotcap):

shell cargo build --release

To build a statically linked version of plotcap, you need the Rust MUSL toolchain, which you can install with:

shell rustup target add x86_64-unknown-linux-musl

...after which you can build it with:

shell cargo build --target=x86_64-unknown-linux-musl --release

The resulting static binary is located at target/x86_64-unknown-linux-musl/release/plotcap.

Usage

```shell plotcap --help plotcap 0.1.3 Simeon Miteff simeon.miteff@corelight.com Plot packet and data rates over time given a PCAP file, with gnuplot.

USAGE: plotcap [OPTIONS] --read --output

OPTIONS: -h, --help Print help information -i, --interval [default: "1 second"] -o, --output -r, --read -V, --version Print version information ```

Examples

smtp.pcap is a ~2h, ~4.3GB file with 8 million packets in it. To reduce the number of plot points we increase the aggregation to 60s with -i 60s:

shell plotcap -r smtp.pcap -i 60s -o smtp-60s.plg

The resulting smtp-60s.plg is 142 lines (5.4KB). Running the script produces:

everything.pcap is a ~37s, ~38GB file with 37 million packets in it. We run plotcap with the default aggregation interval:

shell plotcap -r everything.pcap -o everything.plg

The output file is 60 lines (2.5KB). Running it produces: