A two-audio communicator that uses the VBAN protocol to pass audio to another computer.
This is intended to work on any machine with PulseAudio, but has only been tested on Linux.
For Linux, add a ~/.config/audio-bicycle/config.toml file with the following contents:
toml
local_address = "<local IP address>:<local port>"
dest_address = "<destination IP addres>:<destination port>"
stream_name = "<name>"
Replace each item in <angle brackets> with the appropriate value. By default, VBAN uses port 6980, so if you're unsure
what to use, try that.
Then, cargo install audio-bicycle and run audio-bicycle. It's probably best to set it up as a service:
```systemd
[Unit]
Description=audio-bicycle
BindsTo=pipewire-pulse.service # or pulseaudio.service
After=pipewire-pulse.service # or pulseaudio.service
[Service]
Type=simple
ExecStart=/home/
[Install] WantedBy=default.target ```