assert2

All-purpose assert!(...) and check!(...) macros, inspired by Catch2.

Why these macros?

These macros offer some benefits over the assertions from the standard library: * The macros parse your expression to detect comparisons and adjust the error message accordingly. No more assert_eq or assert_ne, just write assert!(1 + 1 == 2), or even assert!(1 + 1 > 1)! * You can test for pattern matches: assert!(let Err(_) = File::open("/non/existing/file")). * The check macro can be used to perform multiple checks before panicking. * The macros provide more information when the assertion fails. * Colored failure messages!

The macros also accept additional arguments for a custom message, so it is fully comptabible with std::assert. That means you don't have to worry about overwriting the standard assert with use assert2::assert.

Examples

rust check!(6 + 1 <= 2 * 3);

rust check!(true && false);

rust check!(let Ok(_) = File::open("/non/existing/file"));

assert vs check

The crate provides two macros: check!(...) and assert!(...). The main difference is that check doesn't immediately panic. Instead, it will print the assertion error and fail the test. This allows you to run multiple checks and can help to determine the reason of a test failure more easily.

Currently, check uses a scope guard to delay the panic until the current scope ends. Ideally, check doesn't panic at all, but only signals that a test case has failed. If this becomes possible in the future, the check macro will change, so you should not rely on check to panic. You may safely use both macros outside of test cases though.

Difference between stable and nightly.

If available, the crate uses the proc_macro_span feature to get the original source code. On stable and beta, it falls back to stringifying the expression. This makes the output a bit more readable on nightly, but the differences are limited to the displayed expression.

Controlling colored output.

You can force colored output on or off by setting the CLICOLOR environment variable. Set CLICOLOR=1 to forcibly enable colors, or CLICOLORS=0 to disable them. If the environment variable is unset or set to auto, output will be colored if it is going to a terminal.