Arduino MKR WiFi 1000 Board Support Crate

This crate provides a type-safe API for working with the Arduino MKR WiFi 1000 board.

Examples

Blinky Basic

Requirements

• Arduino IDE installed
  • samd package installed (You can do this by going to Tools->Board->BoardManager and then searching for samd
  • Now the arduino distribution contains bossac.exe in ArduinoData/packages/arduino/tools/bossac/1.7.0[-arduino3]/ add it to your path
    • linux: ArduinoData is likely something like ~/.arduino15/
    • OSX: ArduinoData is likely something like ~/Library/Arduino15
  • Now the arduino distribution contains bossac.exe in ArduinoData/packages/arduino/tools/bossac/1.7.0/ add it to your path
    • ArduinoData is likely something like ~/.arduino15/
  • Probably best to install an example sketch via the IDE just to make sure everything is working
  • Note that the arduino cli (or just regular bossac) may soon replace this section
• arm-none-eabi tools installed, you need gcc and objcopy.
  • Note: Alternatively, you can use cargo-binutils, which is likely easier to install on OSX and also easier to use, as it will automatically detect the target
• thumbv6m-none-eabi rust target installed via rustup target add thumbv6m-none-eabi

Steps

Note: Before you run bossac, you need to double-press the center button to reset when re-flashing the device. This sets the device in a bootloader mode.

```bash cargo build --release --example blinkybasic arm-none-eabi-objcopy -O binary target/thumbv6m-none-eabi/release/examples/blinkybasic target/blinky_basic.bin

if using cargo-binutils, you can rust-objcopy with the same flags, or combine the previous 2 steps with cargo objcopy

bossac -i -d -U true -i -e -w -v target/blinky_basic.bin -R ```

(You may need to use --port with something like /dev/ttyACM0 or /dev/ttyACM1